| 1. |
Clean surface area that is to be covered by the hood scoop
with isopropyl alcohol or equivalent. |
| 2. |
Remove the trim underneath the hood. Note: Set
the trim aside as it is to be reattached to the vehicle after
the installation of the hood scoop. |
| 3. |
Peel the tape backing of the locator strip and attach it to
the mounting holes of the hood scoop (Illustration 1). |
| 4. |
Set the hood scoop on the center line of the hood. |
| 5. |
Tape the locator strips on the hood, carefully remove the
hood scoop leaving the locator strips (Illustration 2). |
| 6. |
Center punch the holes for drilling. Drill 3/16" holes
on the two punch mark locations. Use minimum pressure when
drilling to avoid denting of hood. |
| 7. |
Peel the tape backing at the corner (Illustration 3) and
tighten the two screws. |
| 8. |
Peel the tape backing completely and press the hood scoop
gently onto the hood. |
